Upload
jay-r-villanueva
View
221
Download
0
Embed Size (px)
Citation preview
8/3/2019 Resto lec (Amalgam Carving)
1/1
Resto Lec
INSERTING AND CARVING THE AMALGAM
Condensation
Adapt the amalgam to the preparation walls andmatrix.
Produce arestoration free of voids
Lowers the mercury content in the restoration toimprove strength anddecrease corrosion.
Procedure
1. Choose a condenser that can be used withoutbinding.
2. Fill the amalgam carrier the amount ofamalgam thatwill fill the preparation/ min.
3. Use the condenser in apulpal orgingivaldirection.4. Do the lateral condensation5. In the proximal box condense mesially( distally) to
ensure proximal contact with the adjacent tooth
6. C
ontinue the procedure of adding and condensingamalgamuntil half way the preparation depth.7. Change condenser until the preparation us entirely
filledup.8. When occlusalmargins are approaches exercise care
not to insure the enamelmargin.9. The occlusal margin should be covered and over
packedat least 1mm.10.Condensation should be complete within the
-when inserting amalgam into a large preparationbefore the oldmixture reaches its setting time make
a new mixture.- To allow proper condensation, the mix should be
either wet ordry.
Carving the occlusal Portion
1. Burnish the occlusal portion, by moving theburnisher mesiodistally and faciolingually unit it
contacts with the enamel surfaces.2. Use an explorer or hollenback to carefully open or
define the occlusal embrasure:- This procedure will significantly reduce the
danger of marginal fracture during matrixremoval.
3. Complete occlusal carving
4. The matrix removes and access is grained to carve
the axialportion of the restoration.
- the amalgam knives hollenback carver or the side ofan
explorermay be used for carving these area.
5.Burnish the entire surface to rander it smooth.
6. Pass a floss through proximal contact floss not only
remove amalgam shavings but also detects anyamalgam
gingival over hang.
7. If an overhang is detected further use amalgam
knives.
8.Check it restoration is high with the use ofarticulating
paper.
9. Caution patient not to use the new restoration fo
biting or chewing fora few hours.
Two features of the occlusal relationship suggesting the
restoration is high.
1. Cusp tips of the adjacent teeth are in occlusal contact
2. A cusp that occluded with.
FinishingandPolishing the Amalgam
Necessary to correct amarginal discrepancy oimprove the contour.
Polishing an amalgam restoration is notattempted within 24 hours after insertion.
Polishingmay be accomplished with a fine grirubber polishing point or by a rubber cup withpumice followed bya high clusteragent.
Ex. ChuckZinc Oxide